gavthomson
December 6, 2021, 3:08pm
1
Hey All,
Wondering if anyone has a nice DSP setting for single source ‘hifi’. I’ve got a b&o beolit with a chord poly hooked up as my office setup.
It’s common to use crossfeed for headphones, wondering if there is a common single ‘point source’ setting?
Regards
DaveN
December 6, 2021, 5:24pm
2
I don’t have any specific DSP settings to recommend (as in one that would change the perceived sound) but you could set Roon to output in mono:
We didn’t make a mono button, but we did include a matrix mixer in the Procedural EQ using the “Mix” feature. It’s totally possible to mix both channels down to mono if you want:
[image]
Set it up like this:
Left, Left, -3
Right, Right, -3
Left, Right, -3
Right, Left, -3
Pay attention to Headroom Management . If you’re clipping, either make more headroom, or make those -3’s a little bit more negative. You shouldn’t have to go below -6, but it’s nicer to attenuate less when possible.
1 Like
Marin_Weigel
December 6, 2021, 5:50pm
3
Since it’s possible to link two units for stereo, a single one will very likely output a summed mono signal anyways, but there’s not really anything one could do to enhance that.