Nucleus using ip address 10.0.0.5

Roon Software Discussion Nucleus
1

i added a new nucleus server to my system. i can see it connected to my eero router, but it is connected as 10.0.0.5 instead of 192.168.1.x which is the range of addresses i use at home.

A complete reboot of my network does not change this.

Roon server can’t find it there and i can’t access that address through a browser.

Ideas?

2

Adding that it was able to connect an HDMI monitor to the device at it also says “roon OS Web UI can be directly accessed at: http://10.0.0.5. I note that the server is used, not new. i am trying to configure it for a new home

3

Please try this:

4

You might want to check the DHCP settings on your router. I bought a new TP-Link router not long ago and noticed when I first set it up that it started assigning addresses in the 10.0.0.x range even though I set it to 192.168.1.x. I had to tighten up the range on the router to get to act the way I wanted it to.