Ropieee no longer seen as an end point

Support
1

Roon Core Machine

Unraid Docker 20GBs

Networking Gear & Setup Details

Ethernet

Connected Audio Devices

Raspberry Pi 3 using RopieeeXL (but tired Ropieee too)

Number of Tracks in Library

13,000 tracks

Description of Issue

So Core is running just fine. I can stream music from other end points. This issue concerns an endpoint running on a raspberry pi 3 using ropieeeXL. It worked fine w/ no issues until i accidently deleted roonbridge in the web interface to Ropieee. Since then and several ropieee re-flashes, i can no long see it as an endpoint.

Here is the logs i was asked to send.

Unique Identifier
b88c6158c18d3b30

Additional details:
[root@MANCAVE-ROPIEEE ~]# cat /boot/config.txt
gpu_mem=64
initramfs initramfs-linux.img followkernel
boot_delay=1
max_usb_current=1
dtparam=spi=off
start_x=0
dtparam=eee=off
dtparam=eth_max_speed=100
dtparam=eth_led0=4
dtparam=audio=off
dtparam=i2s=on
dtparam=krnbt=off
dtoverlay=allo-digione
[root@MANCAVE-ROPIEEE ~]# aplay -l
card 1: sndallodigione [snd_allo_digione], device 0: Allo DigiOne HiFi wm8804-sp dif-0 [Allo DigiOne HiFi wm8804-spdif-0]
Subdevices: 1/1
Subdevice #0: subdevice #0

Hope someone can point me in the right direction.

Thanks!

2

HI @Hugo_Amaral

Would you be so kind to switch to ‘regular’ RoPieee? I’ve added some stuff to make things more verbose.
@ben from Roon is also up to date with the issue, so maybe we can figure out what’s going on.

Thanks

3

Hi harry-

Sure, i’ve switched it over to regular Ropieee.

Here are the logs:
1b0a5f77559ce43a

Thanks!

4

Can you reboot once more and send me feedback?

Thanks

5

sure!

827fb6b4fb61b077

6

Ok thanks @Hugo_Amaral .

Now, could you do the following:

  • reboot the unit
  • wait until it;s up (5 minutes or so)
  • reboot it again
  • when it’s up send me feedback

Much appreciated!

7

b1f9e5b8d8cc9bcd

and thank you!

8

@Hugo_Amaral ,

Can you do the same exercise exactly again?

Thanks!

9

ab9e62468f055f99

10

@Hugo_Amaral your unit should now be visible in Roon.

11

whoa it sure is. howd you get it to work w/o touching the device itself?

and thank you very much!

1 Like
12

I think there are/were some issues with the Roonbridge update process scripts if another post is what this issue might case.

13

For this (rare) cases RoPieee has the possibility to check for a set of ‘rescue scripts’ (as I like to call them) upon boot and immediately run them.

So in this case I pinpointed it in a few steps (which you were part of) that it had to do with downloading Roon Bridge from Roon’s infrastructure as they made some changes.

You of course thanks in participating in this bug hunt!

Regards,
Harry

14

This topic was automatically closed 45 days after the last reply. New replies are no longer allowed.