Showing (off) your Roon setup - description and photos [2015-04 .. 2021-03]

it took a good while (2.5+ years), but finally got ourselves a place where my larger system could fit. Have slowly been installing it over the past week and on Saturday, somewhere around half past midnight, it was up and running again. A bit dusty and in dire need of exercise. :wink:

This is still a temporary setup. Some machines should be replaced and/or others added. Never thought that receiver would be used again, but buying homes and moving is costly, so there are other priorities higher up at the moment.

Acoustic consultant (the engineer of the speakers actually) is planned for a visit to take care of crossover setup and consulting in regards to room adjustments. Right now the listening window is too narrow for example and should be quite a bit wider apart, but not doing any refinements before his advice.

What is used in this image:
Speakers: Ino Audio i14 (80 Hz and above)
Speakers: Ino Audio infraX-6 (80 Hz and below, waaay below)
Crossover: Ino Audio cr80s
Preamplifier and DAC: Marantz SR5005
Amplifier: Emotiva XPA-5
Source: NUC with ROCK + RP3 running Ropieee

18 Likes