Installation Issue on NUC10i7 [resolved: was hdmi cable issue]

Roon Software Discussion ROCK
1

I’ve managed to set to legacy boot. After selecting USB flash drive by F10 to install ROCK, a few data reading from flash drive noted but nothing prompt on screen for a long time. NUC can’t be power off unless unplug power cord. Have tried using another USB flash drive (Etcher to flash) but same happen. Is there any advice for me ?

2

I never had luck with etcher.I used rufus

3

Have tried rufus. Same situation.

4

Found that it is a display issue. Resolved by switching to a different HDMI cable. Though it takes several trials to locate shared \Data via \ROCK\ successfully, system is running now.

2 Likes
5

This topic was automatically closed 36 hours after the last reply. New replies are no longer allowed.