T+A R 1000 E now with Roon support

Hi all,

we are excited to announce built-in support for Roon in T+A R 1000 E Music Receivers!

Starting with today’s firmware release, all T+A R 1000 E receivers (all the way back to the very earliest models) can stream high-resolution audio directly from Roon!
The volume can comfortably be controlled with your roon remote.

Detailed information on the R 1000 E can be found here: R 1000 E - detailed information

All that is needed to make your R 1000 E receiver roon ready is a simple web based firmware update.

Firmware Update

A description of the firmware update process can be found in the R 1000 E user manual in chapter “Software Update”.

Link to the user manual: R1000E user manual

The software update will need some time. Please be patient and wait until the update process has finished.

After successful installation of the latest firmware the R1000 E should be detected by the roon system and you can find it as a certified roon ready device under Settings/Audio on your roon remote.

Hint for R 1000 E receivers with firmware versions before V 1.07.

If your R 1000 E is running on a streaming client firmware version before V 1.07 (or if your R1000E is not detected by your Roon system after a firmware update) a 2-step update is required. Please proceed as follows:

After doing the firmware update as described above, please switch OFF your R1000E, then switch in ON again.
After the R1000E has re-booted and network connection is established, please start the software update process a second time (the same way as described above).

After completing this second update, your R1000E should now be detected by the Roon system as a roon ready device.


1 Like