I bought a new RPi5 and flashed the Ropieee image as described, but it keeps hanging at a screen showing a “U-boot” picture in the top-right corner. Flashed and re-downloaded the image several times but no difference. The SD card is an official one from RPi5 (bought two with RPi OS pre-installed). Anyone has experience with this? RPi OS boots normally from the 2nd SD card.
Edit: I succesfully flashed a LibreELEC image so what’s wrong with Ropieee?
There’s nothing wrong with RoPieee, I can guaruantee that 
Anyways, what’s the size of your SD card? And can I assume you’re using the latest version?
3 Likes
They are 64GB and yes, latest version. But got it working with DietPi. Allows me to run NAA too, so probably even better. Thanks!
1 Like
NAA is also available in RoPieee, so if at any point you want to try it out let me know.
I‘ve got the same problem here 
.
1 Like
I’m not sure what that means…
Can you give a little bit more information?
I flashed the Ropieee image as described, but it keeps hanging at a screen showing a “U-boot” picture in the top-right corner. Flashed and re-downloaded the image several times but no difference.
System ist Pi5😳
1 Like
I flashed the Ropieee image as described, but it keeps hanging at a screen showing a “U-boot” picture in the top-right corner. Flashed and re-downloaded the image several times but no difference.
System ist Pi5😳
Can you make a picture?
Which software did you use to flash sd card? I have some problem with old version of belenaEtcher. Try newest version Link
Change log of Etcher https://github.com/balena-io/etcher/blob/master/CHANGELOG.md
Well, I’ve tried with the latest version. Could give another try with non-Mac OS PC perhaps. Though with Dietpie all is good. Will Ropieee add it that sense?