Looking to Add A TouchScreen - Using the Allo HAT

[Sheldon_Stokes]

@Nathan_Wilkes

I also use a few “display-only” configurations, so I can place the display where it looks best and place the audio end-point where it close to the DAC.

There was a thread a while back about just the display side of things. I found this DIY display solution elegant and very nice looking. I have to say I’m impressed:

Ropieee with touch screen - decent and good looking case

I recently went with a piece of 1 inch thick piece of Oak; angled at about 30 Degrees; then glued another piece as the stand. Screen mounted the proper way up [20AFE033-01CC-4945-9387-EEB15731E2AF] It’s display only as zone is a Meridian MS200; IR remote control for volume, play/pause etc with a MSR. Connected via WiFi; so it only has a single cable for power.

Sheldon