Hello, after the last SW update my Nucleus+ (rev B) seems stuck in an infinite reboot cycle. I connected a monitor and keyboard, but can’t seem to get any output on the screen nor connect to it on the network. After powering on, the system reboots after about a minute.
I’ve split your reply off into its own thread for better visibility.
Following up on your issue, can you please provide a status update on your Nucleus? If you give both your Nucleus and router a hard reboot (disconnect power cables for a few minutes before rebooting) are you able to access the webUI of your Nucleus?
If you plug a monitor into the Nucleus via HDMI, what do you see? If you could share a screenshot (pending it’s providing output since your last attempt)
I’ll be on standby for your reply. Thanks! 
This topic was automatically closed after 39 days. New replies are no longer allowed.