Reduce stereo using procedural EQ?

[XAVIER_POUYOLLON]

Hi,

How can I create a configuration that has:

• Left Channel: 90% from left + 10% from right channel
• Right Channel: 90% from right + 10% from left channel

using ProceduralEq ?

Thanks.

[DanielAvasilichioaei]

I think such a setup would create problems for out-of-phase (A-B) sounds.
It might work without repercussions for in-phase (A+B) sounds.

[Fred_von_Lohmann1 (Fred von Lohmann)]

Keep in mind that this may kill MQA playback, at least if this bug applies.

[OffRode (What Me Worry?)]

How about trying some crossfeed like you use for headphones playback? Just a thought

[DaveN]

You should take a look at this post:

Can you set Roon to playback in mono

We didn’t make a mono button, but we did include a matrix mixer in the Procedural EQ using the “Mix” feature. It’s totally possible to mix both channels down to mono if you want: [image] Set it up like this: Left, Left, -3 Right, Right, -3 Left, Right, -3 Right, Left, -3 Pay attention to Headroom Management. If you’re clipping, either make more headroom, or make those -3’s a little bit more negative. You shouldn’t have to go below -6, but it’s nicer to attenuate less when possible.

It’s not quite what you asked for, but should provide a starting point.